Remote Access To Device - D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual

Remote Access to Device

On the Advanced / Remote access to device page, you can configure access to the web-based
interface of the access point. By default, the access from external networks to the access point is
closed. If you need to allow access to the access point from the external network, create relevant
rules.
To create a new rule, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter
IP address
Mask
Public port
Protocol
After specifying the needed parameters, click the Apply button.
To edit a rule for remote access, select a needed field in the relevant line of the table, change its
value, and click the Apply button.
To remove a rule for remote access, select the checkbox located to the left of the relevant line in the
table and click the Delete button. Then click the Apply button.
Figure 187. The Advanced / Remote access to device page.
A host or a subnet to which the rule is applied.
The mask of the subnet.
An external port of the access point. You can specify only one port.
The protocol available for remote management of the access point.
Description
Page 241 of 270
Configuring Device (Router Mode)