Routing - D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual

Routing

On the Advanced / Routing page, you can add static routes (routes for networks that are not
connected directly to the device but are available through the interfaces of the device) into the
system.
To create a new route, click the Add button. In the line displayed, you can specify the following
parameters:
Parameter
Destination network
Destination netmask
Gateway
Metric
Via Interface
After specifying the needed parameters, click the Apply button.
Figure 186. The Advanced / Routing page.
A destination network to which this route is assigned.
The destination network mask.
An IP address through which the destination network can be accessed.
The field is available when the <Auto> value is selected from the Via
Interface drop-down list of this line.
A metric for the route. The lower the value, the higher is the route
priority. Optional.
Select an interface through which the destination network can be
accessed from the drop-down list. If you have selected the <Auto>
value of this drop-down list, the access point itself sets the interface on
the basis of data on connected networks.
Page 239 of 270
Configuring Device (Router Mode)
Description