D-Link DAP-1360 User Manual page 143

DAP-1360 Wireless N300 Access Point & Router
User Manual
Figure 109. Configuring PPTP + Dynamic IP WAN connection. The expert settings mode.
Parameter
Isolate connection
Enable RIP
NAT
Firewall
Ping
Click the Next button to continue.
After that the page displaying all specified settings opens. Click the Apply button to create the
connection or the Back button to specify other settings.
After clicking the Apply button, the page for checking the Internet availability opens (see the
Checking Internet Availability section, page 144).
The Miscellaneous section.
Miscellaneous
When the checkbox is selected, the
routing table for this connection. Select the checkbox only when
your ISP requires this.
Select the checkbox to allow using RIP for this connection.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Select the checkbox to allow the
requests from the external network through this connection. For
security reasons, it is recommended not to select this checkbox.
Page 143 of 270
Configuring Device (Router Mode)
Description
access point
access point
uses an alternate
to answer ping