D-Link DAP-1360 User Manual page 199

DAP-1360 Wireless N300 Access Point & Router
User Manual
Parameter
Encryption
Authentication
algorithm
MTU
Keep Alive
Extra options
Dial on demand
Static IP Address
PPP debug
IP received
Isolate connection
Enable RIP
Select a method of MPPE encryption.
No encrypt: MPPE encryption is not applied.
•
MPPE 40/128 bit: MPPE encryption with a 40-bit or 128-bit
•
key is applied.
MPPE 40 bit: MPPE encryption with a 40-bit key is applied.
•
MPPE 128 bit: MPPE encryption with a 128-bit key is
•
applied.
MPPE encryption can be applied only if the MS-CHAP, MS-
CHAP-V2, or AUTO value is selected from the Authentication
algorithm drop-down list.
Select a required authentication method from the drop-down list or
leave the AUTO value.
The maximum size of units transmitted by the interface.
Select the checkbox if you want the access point to
connected to your ISP even when the connection has been inactive
for a specified period of time. When the checkbox is selected, the
LCP interval and LCP fails fields are available. Specify the
required values.
Advanced options of the pppd daemon which need to be specified
for this connection. Optional.
Select the checkbox if you want the access point to establish
connection to the Internet on demand. In the Maximum idle time
field, specify a period of inactivity (in seconds) after which the
connection should be terminated.
Fill in the field if you want to use a static IP address to access the
Internet.
Select the checkbox if you want to log
debugging.
The IP address assigned by the ISP.
When the checkbox is selected, the access point uses an alternate
routing table for this connection. Select the checkbox only when
your ISP requires this.
Select the checkbox to allow using RIP for this connection.
Page 199 of 270
Configuring Device (Router Mode)
Description
all data on PPP connection
keep you