Mitsubishi Electric FX3U-232-BD User Manual page 794

FX Series PLC User's Manual - Data Communication Edition
Remote Maintenance
3. Setting contents of the AT command
When the PLC power is turned ON, the PLC sends the AT command to the modem to initialize the modem.
For reference, the table below shows the set items and setting contents of the AT commands for modems
which are registered in advance in FXGP/WIN.
The set items and setting contents may vary depending on each modem. For actual setting contents, refer to
the manual of the modem to be used.
Set item
Command echo
Number of times of calling
in automatic receiving
Result code display
Result code format
Communication mode
Terminal speed fixing
mode
Send data flow control
Terminal flow control
method
Initialization to values set
in factory before delivery
4
Displaying the selected modem
Verify that the desired modem is set, and click the [OK] button.
I-44
PV-AF288 (AIWA)
ATE0S0=2Q0V1&M4\J0\Q0 ATE0S0=2Q0V1&M4\J0\Q0 ATE0S0=2Q0V1S15=8&H0&R1
E0 (not provided)
S0 = 2 (twice)
Q0 (provided)
V1 (character, word)
&M4 (MNP automatic)
\J0 (fixed)
—
\Q0 (not provided)
&F (FXGP/WIN sends "AT&F", and then sends the AT command above.)
6 How to Setup Modems on the PC Side for Remote Access
PV-AF3360 (AIWA)
E0 (not provided)
S0 = 2 (twice)
Q0 (provided)
V1 (character, word)
&M4 (MNP automatic)
\J0 (fixed)
—
\Q0 (not provided)
On this window, a newly registered modem is selected.
6.2 Setting Using FXGP/WIN
ME3314B (OMRON)
E0 (not provided)
S0 = 2 (twice)
Q0 (provided)
V1 (character, word)
S15 = 8 (V. 42 bis)
—
&H0 (not provided)
&R1 (not provided)