Bgp And Igp Route Redistribution Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

Two routes, 2.2.2.2/32 and 9.1.1.0/24, have been added in Switch A's routing table.
# Display the BGP routing table on Switch C.
[SwitchC] display bgp routing-table ipv4
Total number of routes: 4
BGP local router ID is 3.3.3.3
Status codes: * - valid, > - best, d - dampened, h - history,
Network
* >i 2.2.2.2/32
* >i 3.1.1.0/24
* >i 8.1.1.0/24
* >i 9.1.1.0/24
The output shows that the route 8.1.1.0 becomes valid with the next hop as Switch A.
Verifying the configuration
# Verify that Switch C can ping 8.1.1.1.
[SwitchC] ping 8.1.1.1
Ping 8.1.1.1 (8.1.1.1): 56 data bytes, press CTRL_C to break
56 bytes from 8.1.1.1: icmp_seq=0 ttl=254 time=10.000 ms
56 bytes from 8.1.1.1: icmp_seq=1 ttl=254 time=4.000 ms
56 bytes from 8.1.1.1: icmp_seq=2 ttl=254 time=4.000 ms
56 bytes from 8.1.1.1: icmp_seq=3 ttl=254 time=3.000 ms
56 bytes from 8.1.1.1: icmp_seq=4 ttl=254 time=3.000 ms
--- Ping statistics for 8.1.1.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 3.000/4.800/10.000/2.638 ms

BGP and IGP route redistribution configuration example

Network requirements
As shown in
belong to AS 65009.
Configure BGP and IGP route redistribution to allow Switch A to access network 9.1.2.0/24 in AS
65009, and Switch C to access network 8.1.1.0/24 in AS 65008.
Figure 69 Network diagram
Loop0
1.1.1.1/32
Vlan-int100
8.1.1.1/24
Switch A
s - suppressed, S - stale, i - internal, e - external
Origin: i - IGP, e - EGP, ? - incomplete
NextHop
2.2.2.2
2.2.2.2
3.1.1.2
2.2.2.2
Figure 69, all devices of company A belong to AS 65008, and all devices of company B
AS 65009
AS 65008
EBGP
Vlan-int200 Vlan-int200
3.1.1.2/24 3.1.1.1/24
MED
0
0
0
0
Loop0
2.2.2.2/32
OSPF
Vlan-int300
Vlan-int300
9.1.1.1/24 9.1.1.2/24
Switch B
322
LocPrf PrefVal Path/Ogn
100 0
100 0
100 0
100 0
Loop0
3.3.3.3/32
Vlan-int400
9.1.2.1/24
Switch C
?
?
65008i
?