Configuring Is-Is Network Management; Configuring Is-Is Pic - HP HPE FlexNetwork 7500 series Configuration Manual

Step
2. Enter interface view.
3. Enable prefix suppression
on the interface.

Configuring IS-IS network management

This task includes the following configurations:
•
Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
•
Enable IS-IS notifications to report important events.
Notifications are delivered to the SNMP module, which outputs the notifications according to the
configured output rules. For more information about SNMP notifications, see Network Management
and Monitoring Configuration Guide.
To configure IS-IS network management:
Step
1. Enter system view.
2. Bind MIB to an IS-IS
process.
3. Enable IS-IS notification
sending.
4. Enter IS-IS view.
5. Configure the context
name for the SNMP object
for managing IS-IS.

Configuring IS-IS PIC

Prefix Independent Convergence (PIC) enables the device to speed up network convergence by
ignoring the number of prefixes.
Command
interface interface-type
interface-number
isis prefix-suppression
Command
system-view
isis mib-binding process-id
snmp-agent trap enable isis
[ adjacency-state-change |
area-mismatch | authentication |
authentication-type |
buffsize-mismatch |
id-length-mismatch |
lsdboverload-state-change |
lsp-corrupt | lsp-parse-error |
lsp-size-exceeded |
manual-address-drop |
max-seq-exceeded |
maxarea-mismatch |
own-lsp-purge | protocol-support |
rejected-adjacency |
skip-sequence-number |
version-skew ] *
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
snmp context-name context-name
160
Remarks
N/A
By default, prefix suppression is
disabled on the interface.
This command is also
applicable to the secondary IP
address of the interface.
Remarks
N/A
By default, MIB is bound to the
IS-IS process with the smallest
process ID.
By default, IS-IS notification
sending is enabled.
N/A
By default, no context name is set
for the SNMP object for
managing IS-IS.