Configuring Rip Route Redistribution - HP HPE FlexNetwork 7500 series Configuration Manual

Peer 1.1.1.1 on Vlan-interface100
Local route

Configuring RIP route redistribution

Network requirements
As shown in
through RIP 200.
Configure RIP 200 to redistribute direct routes and routes from RIP 100 on Switch B so Switch C can
learn routes destined for 10.2.1.0/24 and 11.1.1.0/24. Switch A cannot learn routes destined for
12.3.1.0/24 and 16.4.1.0/24.
Figure 8 Network diagram
Vlan-int101
10.2.1.1/24
Switch A
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Switch A.
<SwitchA> system-view
[SwitchA] rip 100
[SwitchA-rip-100] network 10.0.0.0
[SwitchA-rip-100] network 11.0.0.0
[SwitchA-rip-100] version 2
[SwitchA-rip-100] undo summary
[SwitchA-rip-100] quit
# Enable RIP 100 and RIP 200, and configure RIPv2 on Switch B.
<SwitchB> system-view
[SwitchB] rip 100
[SwitchB-rip-100] network 11.0.0.0
[SwitchB-rip-100] version 2
[SwitchB-rip-100] undo summary
[SwitchB-rip-100] quit
[SwitchB] rip 200
[SwitchB-rip-200] network 12.0.0.0
[SwitchB-rip-200] version 2
[SwitchB-rip-200] undo summary
Destination/Mask
2.1.1.0/24
Destination/Mask
1.1.1.0/24
10.1.1.0/24
10.2.1.0/24
Figure 8, Switch B communicates with Switch A through RIP 100 and with Switch C
RIP 100
Vlan-int100
11.1.1.1/24
Eth1/1 Vlan-int100
11.1.1.2/24
Nexthop Cost
1.1.1.3 1
Nexthop Cost
0.0.0.0 0
0.0.0.0 0
0.0.0.0 0
Vlan-int200
12.3.1.1/24
Vlan-int200
12.3.1.2/24
Switch B
46
Tag Flags
0 RAOF
Tag Flags
0 RDOF
0 RDOF
0 RDOF
RIP 200
Vlan-int400
16.4.1.1/24
Switch C
Sec
19
Sec
-
-
-