Setting The Number Of Ospf Logs - HP HPE FlexNetwork 7500 series Configuration Manual

Step
2. Enter OSPF view.
3. Enable PIC for
OSPF.
Configuring BFD for OSPF PIC
By default, OSPF PIC does not use BFD to detect primary link failures. To speed up OSPF
convergence, enable BFD for OSPF PIC to detect the primary link failures.
To configure BFD control packet mode for OSPF PIC:
Step
1. Enter system view.
2. Enter interface view.
3. Enable BFD control packet
mode for OSPF PIC.
To configure BFD echo packet mode for OSPF PIC:
Step
1. Enter system view.
2. Configure the source IP
address of BFD echo
packets.
3. Enter interface view.
4. Enable BFD echo packet
mode for OSPF PIC.

Setting the number of OSPF logs

OSPF logs include LSA aging logs, route calculation logs, and neighbor logs.
To set the number of OSPF logs:
Step
1. Enter system view.
2. Enter OSPF view.
Command
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
pic [ additional-path-always ]
Command
system-view
interface interface-type
interface-number
ospf primary-path-detect bfd
ctrl
Command
system-view
bfd echo-source-ip ip-address
interface interface-type
interface-number
ospf primary-path-detect bfd
echo
Command
system-view
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ]
*
95
Remarks
N/A
By default, OSPF PIC is
enabled.
Remarks
N/A
N/A
By default, BFD control packet
mode for OSPF PIC is disabled.
Remarks
N/A
By default, the source IP address
of BFD echo packets is not
configured.
The source IP address cannot be
on the same network segment as
any local interface's IP address.
For more information about this
command, see High Availability
Command Reference.
N/A
By default, BFD echo packet
mode for OSPF PIC is disabled.
Remarks
N/A
N/A