Page of 5

HP H3C S9500 Configuration

Modular core switches.
Hide thumbs
   

Advertisement

Operation Manual – HA
H3C S9500 Series Routing Switches
Chapter 1 HA Configuration ......................................................................................................... 1-1
1.1 Introduction to HA .............................................................................................................. 1-1
1.2 Configuring HA................................................................................................................... 1-1
1.3 Displaying and Maintaining HA.......................................................................................... 1-3
1.4 HA Configuration Examples............................................................................................... 1-3
1.4.1 Dynamic Upgrade of the System Through HA........................................................ 1-3
1.4.2 Full Mesh Forwarding Mode Configuration Example .............................................. 1-4
Table of Contents
i
Table of Contents

Advertisement

   Summary of Contents for HP H3C S9500

  • Page 1

    Operation Manual – HA H3C S9500 Series Routing Switches Table of Contents Table of Contents Chapter 1 HA Configuration ......................1-1 1.1 Introduction to HA ......................1-1 1.2 Configuring HA........................1-1 1.3 Displaying and Maintaining HA..................1-3 1.4 HA Configuration Examples....................1-3 1.4.1 Dynamic Upgrade of the System Through HA............

  • Page 2

    Operation Manual – HA H3C S9500 Series Routing Switches Chapter 1 HA Configuration Chapter 1 HA Configuration When configuring HA, go to these sections for information you are interested in: Introduction to HA Configuring HA Displaying and Maintaining HA HA Configuration Example 1.1 Introduction to HA...

  • Page 3

    Operation Manual – HA H3C S9500 Series Routing Switches Chapter 1 HA Configuration To do… Use the command… Remarks Enable the manual Optional slave switchover switchover between the [ enable ] Enabled by default AMB and SMB Manually configure switchover between the...

  • Page 4

    Operation Manual – HA H3C S9500 Series Routing Switches Chapter 1 HA Configuration 1.3 Displaying and Maintaining HA To do… Use the command… Remarks Display the switchover display switchover state Available in any view state [ slot-id ] Display Full Mesh...

  • Page 5

    Operation Manual – HA H3C S9500 Series Routing Switches Chapter 1 HA Configuration [Sysname] slave switchover Caution!!! Confirm switch slave to master[Y/N]?y After the switchover, the original AMB will reset, restart, and update its application file. Thus, the whole system has its application upgraded dynamically.

Comments to this Manuals

Symbols: 0
Latest comments: