Configuring Ipv6 Is-Is Route Control - HP HPE FlexNetwork 7500 series Configuration Manual

Step
3. Configure the network entity
title (NET) for the IS-IS
process.
4. Create the IPv6 address
family and enter its view.
5. Return to IS-IS view.
6. Return to system view.
7. Enter interface view.
8. Enable IPv6 for IS-IS on the
interface.

Configuring IPv6 IS-IS route control

Before you configure IPv6 IS-IS route control, complete basic IPv6 IS-IS configuration.
To configure IPv6 IS-IS route control:
Step
1. Enter system view.
2. Enter IS-IS view.
3. Enter IS-IS IPv6 address
family view.
4. Specify a preference for
IPv6 IS-IS routes.
5. Configure an IPv6 IS-IS
summary route.
6. Configure IPv6 IS-IS to
advertise a default route.
7. Configure IPv6 IS-IS to
filter redistributed routes.
8. Configure IPv6 IS-IS to
filter received routes.
9. Configure IPv6 IS-IS to
redistribute routes from
another routing protocol.
Command
network-entity net
address-family ipv6 [ unicast ]
quit
quit
interface interface-type
interface-number
isis ipv6 enable [ process-id ]
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
address-family ipv6 [ unicast ]
preference { route-policy
route-policy-name | preference } *
summary ipv6-prefix prefix-length
[ avoid-feedback | generate_null0_route |
[ level-1 | level-1-2 | level-2 ] | tag tag ] *
default-route-advertise [ avoid-learning |
[ level-1 | level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
filter-policy { ipv6-acl-number | prefix-list
prefix-list-name | route-policy
route-policy-name } export [ protocol
[ process-id ] ]
filter-policy { ipv6-acl-number | prefix-list
prefix-list-name | route-policy
route-policy-name } import
import-route protocol [ as-number |
process-id ] [ allow-ibgp ] [ allow-direct |
cost cost-value | [ level-1 | level-1-2 |
level-2 ] | route-policy route-policy-name |
tag tag ] *
474
Remarks
By default, no NET is configured.
By default, no IS-IS IPv6 address
family exists.
N/A
N/A
N/A
By default, IPv6 is disabled for
IS-IS on an interface.
Remarks
N/A
N/A
N/A
By default, the default
setting is 15.
By default, no IPv6 IS-IS
summary route is
configured.
By default, IPv6 IS-IS does
not advertise Level-1 and
Level-2 default routes.
By default, IPv6 IS-IS does
not filter redistributed
routes.
This command is usually
used together with the
import-route command.
By default, IPv6 IS-IS does
not filter received routes.
By default, IPv6 IS-IS does
not redistribute routes from
any other routing protocol.