HP HPE FlexNetwork 7500 series Configuration Manual page 68

[SwitchC-rip-1] version 2
[SwitchC-rip-1] undo summary
[SwitchC-rip-1] network 192.168.1.0
[SwitchC-rip-1] network 192.168.3.0
[SwitchC-rip-1] import-route static
[SwitchC-rip-1] quit
3. Configure BFD parameters on VLAN-interface 100 of Switch A.
[SwitchA] bfd echo-source-ip 11.11.11.11
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] bfd min-transmit-interval 500
[SwitchA-Vlan-interface100] bfd min-receive-interval 500
[SwitchA-Vlan-interface100] bfd detect-multiplier 7
[SwitchA-Vlan-interface100] quit
[SwitchA] quit
4. Configure a static route on Switch C.
[SwitchC] ip route-static 120.1.1.1 24 null 0
Verifying the configuration
# Display the BFD session information on Switch A.
<SwitchA> display bfd session
Total Session Num: 1
IPv4 Session Working Under Echo Mode:
LD
4
# Display RIP routes destined for 120.1.1.0/24 on Switch A.
<SwitchA> display ip routing-table 120.1.1.0 24
Summary count : 1
Destination/Mask
120.1.1.0/24
The output shows that Switch A communicates with Switch C through VLAN-interface 100. Then the
link over VLAN-interface 100 fails.
# Display RIP routes destined for 120.1.1.0/24 on Switch A.
<SwitchA> display ip routing-table 120.1.1.0 24
Summary count : 1
Destination/Mask
120.1.1.0/24
The output shows that Switch A communicates with Switch C through VLAN-interface 200.
Up Session Num: 1
SourceAddr DestAddr
192.168.1.1 192.168.1.2
Proto Pre Cost
RIP 100 1
Proto Pre Cost
RIP 100 1
Init Mode: Active
State Holdtime
Up 2000ms
NextHop
192.168.1.2
NextHop
192.168.2.2
56
Interface
Vlan100
Interface
Vlan-interface100
Interface
Vlan-interface200