Displaying And Maintaining Ipv6 Static Routes - HP 3100-8 v2 SI Configuration Manual

Hp 3100 v2 switch series
Table of Contents

Advertisement

Step
2.
Configure an IPv6 static route.
NOTE:
If you specify a broadcast interface, such as a VLAN interface, as the output interface for a static route,
you must specify the next hop address.

Displaying and maintaining IPv6 static routes

Task
Display IPv6 static route
information.
Remove all IPv6 static routes.
To delete a single IPv6 static route, use the undo ipv6 route-static command. To delete all IPv6 static
routes, including the default route, use the delete ipv6 static-routes all command.
For more information about the display ipv6 routing-table protocol static [ inactive | verbose ] [ | { begin
| exclude | include } regular-expression ] command, see Layer 3—IP Routing Command Reference.
Command
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address }
[ preference preference-value ]
Command
display ipv6 routing-table protocol
static [ inactive | verbose ] [ |
{ begin | exclude | include }
regular-expression ]
delete ipv6 static-routes all
8
Remarks
Required
The default
preference of IPv6
static routes is 60.
Remarks
Available in any view
Available in system view

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents