HP HPE FlexNetwork 7500 series Configuration Manual page 298

Step
3. Enable BGP route refresh for
a peer or peer group.
Saving updates
To save all route updates from the specified peer or peer group (IPv4 unicast/multicast address
family):
Step
1. Enter system view.
2. Enter BGP IPv4 unicast
address family view,
BGP-VPN IPv4 unicast
address family view, or BGP
IPv4 multicast address family
view.
3. Save all route updates from
the peer or peer group.
Command
•
Enable BGP route refresh for
the specified peer or peer
group:
peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
route-refresh
•
Enable the BGP route
refresh, multi-protocol
extension, and 4-byte AS
number features for the
specified peer or peer group:
undo peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
conventional
Command
system-view
•
Enter BGP IPv4 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv4
[ unicast ]
•
Enter BGP-VPN IPv4 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv4
[ unicast ]
•
Enter BGP IPv4 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv4
multicast
peer { group-name | ipv4-address
[ mask-length ] } keep-all-routes
286
Remarks
By default, the BGP route refresh,
multi-protocol extension, and
4-byte AS number features are
enabled.
Remarks
N/A
N/A
By default, the routes are not
saved.
This command takes effect only
for the routes received after this
command is executed.