HP HPE FlexNetwork 7500 series Configuration Manual page 410

Figure 91 Network diagram
Host A
1::2/64
Configuration procedure
1. Configure the IPv6 addresses for all VLAN interfaces. (Details not shown.)
2. Configure IPv6 static routes:
# Configure a default IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure a default IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6 route-static :: 0 5::2
3. Configure the IPv6 addresses for all the hosts and configure the default gateway of Host A,
Host B, and Host C as 1::1, 2::1, and 3::1.
Verifying the configuration
# Display the IPv6 static route information on Switch A.
[SwitchA] display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination: ::
NextHop
Interface
Static Routing table Status : <Inactive>
Summary Count : 0
# Display the IPv6 static route information on Switch B.
[SwitchB] display ipv6 routing-table protocol static
Vlan-int200
4::2/64
Switch B
Vlan-int200
4::1/64
Vlan-int100
1::1/64
Switch A
: 4::2
: Vlan-interface200
Host B
2::2/64
Vlan-int400
2::1/64
Vlan-int300
5::2/64
Vlan-int300
5::1/64
Vlan-int500
3::1/64
Switch C
398
Host C
3::2/64
Protocol : Static
Preference: 60
Cost : 0