Port-Based Ipv6 Multicast Vlan Configuration Example - HP FlexNetwork 7500 Series Configuration Manual

[SwitchB] display ipv6 multicast-vlan group
Total 1 entries.
IPv6 multicast VLAN 10: Total 1 entries.
(::, FF1E::101)
Sub-VLANs (3 in total):
VLAN 2
VLAN 3
VLAN 4
The output shows that IPv6 multicast group FF1E::101 belongs to IPv6 multicast VLAN 10. IPv6
multicast VLAN 10 contains sub-VLANs VLAN 2 through VLAN 4. Switch B will replicate the IPv6
multicast data of VLAN 10 to VLAN 2 through VLAN 4.

Port-based IPv6 multicast VLAN configuration example

Network requirements
As shown in
•
MLDv1 runs on Switch A. MLDv1 snooping runs on Switch B.
•
Switch A acts as the MLD querier.
•
The IPv6 multicast source sends IPv6 multicast data to IPv6 multicast group FF1E::101.
Receivers Host A, Host B, and Host C belong to VLAN 2, VLAN 3, and VLAN 4, respectively.
Configure a port-based IPv6 multicast VLAN on Switch B to meet the following requirements:
•
Switch A sends IPv6 multicast data to Switch B through the IPv6 multicast VLAN.
•
Switch B forwards the IPv6 multicast data to the receivers in different user VLANs.
Figure 84 Network diagram
Configuration procedure
Configure Switch A:
1.
# Enable IPv6 multicast routing.
<SwitchA> system-view
Figure 84:
270