Cable Entry Knockouts, Wall-/Pipe-Mount Analyzer - ABB AX410 User Manual

Single and Dual Input Analyzers for Low Level Conductivity
AX410, AX411, AX413, AX416, AX418, AX450, AX455 & AX456

6.3.2 Cable Entry Knockouts, Wall-/Pipe-mount Analyzer

The analyzer is supplied with 7 cable glands, one fitted and six to be fitted, as required, by the user - see Fig. 6.7.
Release the four captive
screws and remove
the terminal cover plate
Secure the cable
gland with the nut
Fig. 6.7 Cable Entry Knockouts, Wall-/Pipe-mount Analyzer
IM/AX4CO Issue 11
1
6
Insert the cable gland into the hole
5
in the analyzer case from the outside
Factory-fitted cable gland
Place the blade of a small, flat bladed screwdriver
2
into the knockout groove and tap the
screwdriver smartly to remove the knockout
(see Note below)
Smooth the edges of the hole
3
with a small round or half-round file
4
Fit an 'O' ring seal to the the cable gland
6 INSTALLATION
Cable entry knockouts
55