Mitsubishi Electric L02SCPU User's Manual And Reference page 293

Melsec-l series, cpu module
Table of Contents

Advertisement

● When changing device points, the following refresh ranges must not exceed the corresponding device ranges.
• Link refresh with CC-Link IE Field Network master/local module
• Link refresh with CC-Link IE Field Network Basic
• Auto refresh with CC-Link
• Auto refresh with intelligent function module
If device points are set exceeding the corresponding device range, data may be written to any other device or an error
may occur.
● If the device points of the internal user devices are changed and the parameters are written from the "Write to PLC"
screen, the device address may be shifted and does not correspond to the original stored value. Because the shifted
value might be used for the operation, the following files, which are created by using the parameters before the device
point change, cannot be used under existing condition.
• Sequence program files
• SFC program files
• ST program files
When change the device points of the internal user devices, perform the following operations from a programming tool.
[Before changing the device points of the internal user devices]
Read devices to be used and each program from the CPU module.
[After the device points of the internal user devices are changed]
Write the devices and each program, which were read before the device point change, to the CPU module.
For the read/write of devices and programs, refer to the following.
Operating manual for the programming tool used
(2) Memory size
Set the internal user devices so that the following condition is satisfied.
(Bit device size) + (Timer, retentive timer, and counter sizes) + (Word device size)  29K words
• For bit devices, 16 points are calculated as one word.
• For the timer, retentive timer, and counter, 16 points are calculated as 18 words.
(Timer, retentive timer, or counter size) =
• For word devices, 16 points are calculated as 16 words.
(X + Y + M + L + B + F + SB + V + S)
(Bit device size) =
(D + W + SW)
(Word device size) =
(Words)
16
(T + ST + C)
18 (Words)
16
16 (Words)
16
CHAPTER 5 DEVICES
5
291

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents