Mitsubishi Electric L02SCPU User's Manual And Reference page 142

(7) Batch-disabling executional conditioned device test settings
1.
Open the following message box.
[Debug]  [Executional Conditioned Device Test]  [Batch Disable Executional Conditioned Device
Test]
This operation is also available from the "Check/Disable Executional Conditioned Device Test Registration"
dialog box.
(8) Conditions that registration or disabling is not available
In the following cases, executional conditioned device test setting cannot be registered or disabled. When
multiple device settings are to be registered, no setting can be registered if any of them is invalid.
(a) Settings cannot be registered if:
• Specified program name, step, or device does not exist or
• The number of registered settings exceeds 32.
(b) Settings cannot be disabled if:
• Specified program name, step, or device does not exist or
• No executional conditioned device test setting has been registered.
(9) Precautions
(a) Priority
If any of the following functions is set in the same step number that is specified by the executional conditioned
device test setting, the executional conditioned device test takes priority over the other functions.
• Monitor condition setting
• Sampling trace function (trace point or trigger point)
• Scan time measurement (start step or end step)
(b) Executional conditioned device test and writing data to the running CPU module
• If the executional conditioned device test is executed during execution of an online change function, only
the online change function is completed while the executional conditioned device test is not executed. The
following message box appears. Execute the executional conditioned device test again after the online
change has been completed.
• If the online change function is executed during execution of the executional conditioned device test, only
the online change function is completed. The executional conditioned device test setting registered in the
ladder block that was changed online, the corresponding setting is disabled.
140