Mitsubishi Electric L02SCPU User's Manual And Reference page 245

(4) Display format
The following table shows display format available for device monitor/test.
Format
16-bit integer
32-bit integer
Real number (single
*1
precision)
Real number (double
*1
precision)
*1 Device test cannot be executed while a value is displayed in real number. (except for bit device, timer (T), retentive timer
(ST), and counter (C))
Also, a device number can be displayed with device comment. Note that, however, the device comment can be
displayed up to 5 two-byte characters (11 one-byte characters).
(a) Specifying display format
Perform the following operation.
"Device monitor" screen
"Display format selection" screen
Numeric
Bit display
value
Decimal
Available
Hexadecimal
Decimal
Hexadecimal
Not available


CHAPTER 4 DISPLAY UNIT FUNCTIONS
Remarks
A sign is appended for negative values only.
When a value is less than four digits, "0" is assigned for the remaining digits.
A sign is appended for minus values only.
When a value is less than eight digits, "0" is assigned for the remaining digits.
A value is displayed in floating point exponent (2 lines). A sign is appended
for negative values only.
A value is displayed in floating point exponent (2 lines). A sign is appended
for negative values only.
1.
Press the  button.
2.
Select display format using the  and  buttons
and press the button.
OK
4
243