Mitsubishi Electric L02SCPU User's Manual And Reference page 244

(2) Devices that can be monitored/tested
The following shows devices that can be monitored and tested by device monitor/test. Note that local devices
cannot be monitored and tested.
Type
Bit device
Word device
*1 Digit-specified devices, devices specified by indirect specification, and bit-specified devices cannot be set.
*2 Device test cannot be executed.
(3) Specifying a device to be monitored or tested
Perform the following operation.
"Device monitor" screen
"Device selection" screen
"Device No. setting" screen
*1 The device number is displayed in decimal or hexadecimal, according to the notation of each device. Regardless of the
notation, the device number is displayed with the number of digits that can be set.
242
X, Y, M, L, B, F, SB, V, SM, T (contact, coil
D, D (extended data register), W, W (extended link register), SW, SD, Z, R, ZR, T (current value), ST (current
value), C (current value)


*1
Device
*2 *2
), ST (contact, coil ), C (contact, coil
1.
Press the  button.
2.
Select a target device using the  and  buttons
and press the button.
OK
3.
Move the cursor using the  and  buttons,
increase or decrease a device number
and  buttons, and press the
*2
)
*1
using the 
button.
OK