Appendix 1.4 Remote Password Setting - Mitsubishi Electric L02SCPU User's Manual And Reference

Appendix 1.4
This section provides the remote password setting screens and details of the setting items.
Item
Password Setting
Model Name
Start X/Y
User Connection No.
Password
Active
Module
System Connection
Condition
Setting
(detailed
setting)
Regard as Error
when Remote
Password
Mismatch Count
Reaches Upper
Limit
*1 This is a connection used by users for communications using the MC protocol or fixed buffer.
*2 This is a connection used by a system for FTP or MELSOFT (TCP/IP, UDP/IP) communications.
*3 For details on the LJ71E71-100 settings, refer to the following.
MELSEC-L Ethernet Interface Module User's Manual (Basic)
After setting a remote password, store the parameters in the parameter-valid drive.
Remote password setting
Enter a remote password.
Select a model name of the CPU module.
Set the start address of the module.
Configure the detailed setting when selecting the

LCPU.
*1
Select a user connection number(s).
Select a port(s) where the remote password is
*2*3
enabled.
Set whether to generate an error when the

number of mismatches on remote password
reaches to the upper limit.
Upper
Set the upper limit of the number of remote
Limit of
password mismatches.
Mismatch
Description
Up to four characters (alphanumeric
characters, special symbols)
• Ethernet_Built-in_CPU
• LJ71C24
• LJ71E71-100
0000
Connection 1 to Connection 16
• MELSOFT Transmission Port (TCP/IP)
• MELSOFT Transmission Port (UDP/IP)
• FTP Transmission port (TCP/IP)
• Direct Connection of MELSOFT
Deselected
1 to 65535 (default: 10 (Count))
APPX
Setting range
to 0FE0
H H

375
A