Mitsubishi Electric L02SCPU User's Manual And Reference page 208

(4) Batch save status
The batch save status can be checked in SD635 (Project data batch save status).
SD635 value
0
H
1
H
2
H
FF
H
(5) Causes of a batch save error
When the batch save processing has failed, a diagnostic error is not detected. An error message is displayed on
the display unit and the error cause is stored in SD634 (Project data batch save error cause).
SD634 value
100
H
101
H
200
H
201
H
202
H
300
H
400
H
401
H
500
H
503
H
504
H
505
H
510
H
600
H
601
H
602
H
604
H
607
H
608
H
701
H
*1 The number of save-target system files (up to five files) and its size (up to 10KB) are included.
*2 If the function is executed again and the same error occurs, the possible cause is a hardware failure of the CPU module
or SD memory card. Please consult your local Mitsubishi representative.
206
Batch save status
Batch save not executed
Batch save being executed
Batch save completed
Batch save error
• An SD memory card is not inserted.
• The SD memory card lock switch of the CPU module is not slid down.
Use of an SD memory card is disabled by SM606 (SD memory card forced disable instruction).
• Size of data to be batch-saved exceeds the capacity of the SD memory card.
• The number of files to be batch-saved exceeds the number of storable files of the SD memory card.
The number of files to be batch-saved exceeds 1024.
More than 100 folders exist in the "SaveLoad" folder.
The SD memory card is write-protected.
Writing data to the SD memory card has failed.
The SD memory card was removed during the batch save processing.
Reading data from the target drive (program memory) has failed.
Reading data from the target drive (standard RAM) has failed.
Reading data from the target drive (standard ROM) has failed.
Reading data from the target drive (SD memory card) has failed.
Reading data from the target drive (system data) has failed.
The batch save function was executed during the latch data backup to the standard ROM.
The batch save function was executed during online change.
The batch save function was executed with an FTP client connected to and communicated with the CPU module.
The batch save function was executed while the CPU module change function with SD memory card was being
executed.
The batch save function was executed while the iQ Sensor Solution function (data backup/restoration) was being
executed.
The batch save function was executed while the file transfer function (FTP client) was being executed.
The batch save function was executed for the program for which a block password was set and "Execution Program
Protection Setting" of the password was enabled.
Description
The batch save function is not executed.
The batch save function is being executed.
The batch save processing is completed successfully.
The batch save processing has failed and an error occurs.
Description
*2
*2
*2
*2
*2
*2
*1
*1