Custom Default; Firmware Upgrade - ZyXEL Communications XGS2210-28 User Manual

Click OK to continue or Cancel to abort.
2
Figure 336 Load Factory Default: Start
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1 or DHCP-
assigned IP).

44.5.3 Custom Default

Follow the steps below to reset the Switch back to the Custom Default configurations file you created.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Click the Custom Default button.
1
Click OK to continue or Cancel to abort.
2
Note: If you did not save a Custom Default file in the web configurator or CLI using copy
running-config custom-default, then the factory default file is restored after you
press click Custom Default (next to Reboot System) on the Switch. You will then have to
make all your configurations again on the Switch.
Figure 337 Load Custom Default: Start

44.6 Firmware Upgrade

Use the following screen to upgrade your Switch to the latest firmware. The Switch supports dual
firmware images, Firmware 1 and Firmware 2. Use this screen to specify which image is updated when
firmware is uploaded using the web configurator and to specify which image is loaded when the Switch
starts up.
Make sure you have downloaded (and unzipped) the correct model firmware and version to your
computer before uploading to the device.
Be sure to upload the correct model firmware as uploading the wrong
model firmware may damage your device.
Click Management > Maintenance > Firmware Upgrade to view the screen as shown next.
Chapter 44 Maintenance
XGS2210 Series User's Guide
428