Link Aggregation Control Protocol - ZyXEL Communications XGS2210-28 User Manual

Table 72 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Criteria
Slot (Stacking
mode)
Port
(Standalone or
stacking
mode)
Group
Apply
Cancel

17.3.1 Link Aggregation Control Protocol

Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen
shown next. See
aggregation.
Chapter 17 Link Aggregation
DESCRIPTION
Select the outgoing traffic distribution type. Packets from the same source and/or to the same
destination are sent over the same link within the trunk. By default, the Switch uses the src-dst-mac
distribution type. If the Switch is behind a router, the packet's destination or source MAC address
will be changed. In this case, set the Switch to distribute traffic based on its IP address to make
sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
This field appears only in stacking mode. Click the drop-down list to choose the slot number of the
Switch in a stack.
This field displays the port number. In stacking mode, the first number is the slot ID and the second
is the port number.
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port
security settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Dynamic Link Aggregation on page 178
XGS2210 Series User's Guide
for more information on dynamic link
184