Activate Mac Authentication - ZyXEL Communications XGS2210-28 User Manual

The following table describes the labels in this screen.
Table 75 Advanced Application > Port Authentication > 802.1x > Guest VLAN
LABEL
Slot (Stacking
mode)
Port (Standalone
or stacking
mode)
*
Active
Guest Vlan
Host-mode
Multi-Secure Num
Apply
Cancel

18.4 Activate MAC Authentication

Use this screen to activate MAC authentication. In the Port Authentication screen click MAC
Authentication to display the configuration screen as shown.
Chapter 18 Port Authentication
DESCRIPTION
This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
This field displays a port number. In stacking mode, the first number is the slot ID and the second
is the port number. * means all ports.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this checkbox to enable the guest VLAN feature on this port.
Clients that fail authentication are placed in the guest VLAN and can receive limited services.
A guest VLAN is a pre-configured VLAN on the Switch that allows non-authenticated users to
access limited network resources through the Switch. You must also enable IEEE 802.1x
authentication on the Switch and the associated ports. Enter the number that identifies the
guest VLAN.
Make sure this is a VLAN recognized in your network.
Specify how the Switch authenticates users when more than one user connect to the port
(using a hub).
Select Multi-Host to authenticate only the first user that connects to this port. If the first user
enters the correct credential, any other users are allowed to access the port without
authentication. If the first user fails to enter the correct credential, they are all put in the guest
VLAN. Once the first user who did authentication logs out or disconnects from the port, rest of
the users are blocked until a user does the authentication process again.
Select Multi-Secure to authenticate each user that connects to this port.
If you set Host-mode to Multi-Secure, specify the maximum number of users that the Switch will
authenticate on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
195