Error-Disable Recovery Configuration - ZyXEL Communications XGS2210-28 User Manual

31.6 Error-Disable Recovery Configuration

Use this screen to configure the Switch to automatically undo an action after the error is gone. Click the
Click Here link next to Errdisable Recovery in the Advanced Application > Errdisable screen to display
the screen as shown.
Figure 251 Advanced Application > Errdisable > Errdisable Recovery
The following table describes the labels in this screen.
Table 145 Advanced Application > Errdisable > Errdisable Recovery
LABEL
Active
Reason
*
Timer Status
Interval
Apply
Cancel
Chapter 31 Error Disable
DESCRIPTION
Select this option to turn on the error-disable recovery function on the Switch.
This field displays the supported features that allow the Switch to shut down a port or discard
packets on a port according to the feature requirements and what action you configure.
Use this row to make the setting the same for all entries. Use this row first and then make
adjustments to each entry if necessary.
Changes in this row are copied to all the entries as soon as you make them.
Select this option to allow the Switch to wait for the specified time interval to activate a port or
allow specific packets on a port, after the error was gone. Deselect this option to turn off this
rule.
Enter the number of seconds (from 30 to 2592000) for the time interval.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
329