Ipv6 Source Guard Policy Setup - ZyXEL Communications XGS2210-28 User Manual

Table 122 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (continued)
LABEL
Cancel
Clear
Index
Source Address
MAC Address
VLAN
Port
Delete
Cancel

26.14 IPv6 Source Guard Policy Setup

Use this screen to have IPv6 source guard forward valid IPv6 addresses and/or IPv6 prefixes that are
stored in the binding table and allow or block data traffic from all link-local addresses. To open this
screen, click Advanced Application > IP Source Guard > IPv6 Source Guard Policy Setup.
• If you select Validate Address and not Validate Prefix, traffic for a binding entry that matches an IPv6
address and VLAN ID, port number, and MAC address will be forwarded. If this binding entry is an IPv6
prefix, the traffic will be denied.
• If you select Validate Prefix and not Validate Address, traffic for a binding entry that matches an IPv6
prefix and VLAN ID, port number, and MAC address will be forwarded. If this binding entry is an IPv6
address, the traffic will be denied.
• If you select both Validate Prefix and Validate Address then traffic matching either IPv6 address or
prefix will be forwarded.
Figure 215 Advanced Application > IP Source Guard > IPv6 Source Guard Policy Setup
Chapter 26 IP Source Guard
DESCRIPTION
Click this to reset the values above based or if not applicable, to clear the fields above.
Click this to clear the fields above.
This field displays a sequential number for each binding.
This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
This field displays the port number in the binding. If this field is blank, the binding applies to all
ports.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Select an entry checkbox and click Delete to remove the specified entry.
Click this to clear the check boxes above.
XGS2210 Series User's Guide
286