Ip Source Guard Screen; Ipv4 Source Guard Setup - ZyXEL Communications XGS2210-28 User Manual

26.2 IP Source Guard Screen

Use this screen to go to the configuration screens where you can configure IPv4 or IPv6 source guard
settings. Click Advanced Application > IP Source Guard in the navigation panel.
Figure 195 Advanced Application > IP Source Guard
The following table describes the labels in this screen.
Table 107 Advanced Application > IP Source Guard
LABEL
IPv4 Source Guard
Setup
IPv6 Source
Binding Status
IPv6 Static Binding
Setup
IPv6 Source Guard
Policy Setup
IPv6 Source Guard
Port Setup
IPv6 Snooping
Policy Setup
IPv6 Snooping
VLAN Setup
IPv6 DHCP Trust
Setup

26.3 IPv4 Source Guard Setup

Use this screen to look at the current bindings for DHCP snooping and ARP inspection. Bindings are used
by DHCP snooping and ARP inspection to distinguish between authorized and unauthorized packets in
the network. The Switch learns the bindings by snooping DHCP packets (dynamic bindings) and from
information provided manually by administrators (static bindings). To open this screen, click Advanced
Application > IP Source Guard > IPv4 Source Guard Setup.
Chapter 26 IP Source Guard
DESCRIPTION
Click the link to open screens where you can view and manage static bindings, configure
DHCP snooping or ARP inspection and look at various statistics.
Click the link to open a screen where you can view the current IPv6 dynamic and static
bindings or remove dynamic bindings based on IPv6 address and/or IPv6 prefix.
Click the link to open a screen where you can manually create IPv6 source guard static
binding entries.
Click the link to open a screen where you can define policies to have IPv6 source guard
forward valid addresses and/or prefixes and allow or block data traffic from all link-local
addresses.
Click the link to open a screen where you can apply the configured IPv6 source guard policy
to a port.
Click the link to open a screen where you can set up DHCPv6 snooping policies for the
binding table.
Click the link to open a screen where you can enable a DHCPv6 snooping policy on a
specific VLAN interface.
Click the link to open a screen where you can specify which ports are trusted for DHCPv6
snooping.
XGS2210 Series User's Guide
263