Pppoe Ia For Vlan - ZyXEL Communications XGS2210-28 User Manual

30.3.3 PPPoE IA for VLAN

Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the
Switch appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN.
Click the VLAN link in the Intermediate Agent screen to display the screen as shown.
Figure 244 Advanced Application > PPPoE > Intermediate Agent > VLAN
The following table describes the labels in this screen.
Table 140 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL
Show VLAN
Start VID
End VID
Apply
VID
*
Enabled
Circuit-id
Remote-id
Apply
Cancel
Chapter 30 PPPoE
DESCRIPTION
Use this section to specify the VLANs you want to configure in the section below.
Enter the lowest VLAN ID you want to configure in the section below.
Enter the highest VLAN ID you want to configure in the section below.
Click Apply to display the specified range of VLANs in the section below.
This field displays the VLAN ID of each VLAN in the range specified above. If you configure the *
VLAN, the settings are applied to all VLANs.
Use this row to make the setting the same for all VLANs. Use this row first and then make
adjustments on a VLAN-by-VLAN basis.
Changes in this row are copied to all the VLANs as soon as you make them.
Select this option to turn on the PPPoE Intermediate Agent on a VLAN.
Select this option to make the Circuit ID settings for a specific VLAN take effect.
Select this option to make the Remote ID settings for a specific VLAN take effect.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
320