Viewing And Editing Classifier Configuration Summary - ZyXEL Communications XGS2210-28 User Manual

Table 80 Advanced Application > Classifier > Classifier Configuration (continued)
LABEL
Destination
Socket
Number
Add
Cancel
Clear

21.3.1 Viewing and Editing Classifier Configuration Summary

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the
Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over lower layer
rule.
Figure 160 Advanced Application > Classifier > Classifier Configuration: Summary Table
The following table describes the labels in this screen.
Table 81 Advanced Application > Classifier > Classifier Configuration: Summary Table
LABEL
Index
Active
Weight
Name
Rule
Delete
Cancel
Chapter 21 Classifier
DESCRIPTION
Note: You must select either UDP or TCP in the IP Protocol field before you configure the
socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and
enter a TCP/UDP protocol port number. Refer to
Click Add to insert the entry in the summary table below and save your changes to the Switch's run-
time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on
the top navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to reset the fields back to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
DESCRIPTION
This field displays the index number of the rule. Click an index number to edit the rule.
This field displays Yes when the rule is activated and No when it is deactivated.
The field displays the priority of the rule when the match order is in manual mode. A higher weight
means a higher priority.
This field displays the descriptive name for this rule. This is for identification purpose only.
This field displays a summary of the classifier rule's settings.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the table
heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
XGS2210 Series User's Guide
Table 84 on page 211
210
for more information.