Port-Based Vlan Setup; Configure A Port-Based Vlan - ZyXEL Communications XGS2210-28 User Manual

Table 51 Advanced Application > VLAN > VLAN Configuration > MAC Based VLAN Setup
LABEL
Index
Name
MAC Address
VID
Priority
Delete
Cancel

9.11 Port-Based VLAN Setup

Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish to
allow two subscriber ports to talk to each other, for example, between conference rooms in a hotel, you
must define the egress (an egress port is an outgoing port, that is, a port through which a data packet
leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as IP Setup and Filtering) that require a VID, you must enter 1 as the VID.
The port-based VLAN setup screen is shown next. The CPU management port forms a VLAN with all
Ethernet ports.

9.11.1 Configure a Port-Based VLAN

Select Port Based as the VLAN Type in the Basic Setting > Switch Setup screen and then click Advanced
Application > VLAN from the navigation panel to display the next screen.
Chapter 9 VLAN
DESCRIPTION
This field displays the index number of the MAC-based VLAN entry.
This field displays the name of the MAC-based VLAN entry.
This field displays the source MAC address that is bind to the MAC-based VLAN entry.
This field displays the VLAN ID of the MAC-based VLAN entry.
This field displays the priority level of the MAC-based VLAN entry.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
XGS2210 Series User's Guide
126