Configure Vlan Port Settings - ZyXEL Communications XGS2210-28 User Manual

Table 46 Advanced Application > VLAN > VLAN Configuration > Static VLAN Setup (continued)
LABEL
Port
*
Control
Tagging
Add
Cancel
Clear
VID
Active
Name
VLAN Type
Association
VLAN List
Delete
Cancel

9.6 Configure VLAN Port Settings

Use the VLAN Port Setup screen to configure the static VLAN (IEEE 802.1Q) settings on a port. Click the
VLAN Port Setup link in the VLAN Configuration screen.
Chapter 9 VLAN
DESCRIPTION
The port number identifies the port you are configuring. In stacking mode, the first number
represents the slot and the second the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select Normal for the port to dynamically join this VLAN group using GVRP. This is the default
selection.
Select Fixed for the port to be a permanent member of this VLAN group.
Select Forbidden if you want to prohibit the port from joining this VLAN group.
Select TX Tagging if you want the port to tag all outgoing frames transmitted with this VLAN
Group ID.
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to change the fields back to their last saved values.
Click Clear to start configuring the screen again.
This field displays the ID number of the VLAN group. Click the number to edit the VLAN settings.
This field indicates whether the VLAN settings are enabled (Yes) or disabled (No).
This field displays the descriptive name for this VLAN group.
This field displays the Normal or Private (Primary, Isolated or Community) type VLAN configured
in the top part of this screen.
This field displays which secondary private VLANs are associated with a primary private VLAN
configured in the top part of this screen.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
XGS2210 Series User's Guide
116