ZyXEL Communications XGS2210-28 User Manual page 62

The following table describes the fields in the above screen.
Table 10 Status > Neighbor
LABEL DESCRIPTION
Local
Port This shows the port of the Switch, on which the neighboring device is discovered.
Desc. This shows the port description of the Switch.
PoE Draw This shows the consumption that the neighboring device connected to this port draws
from the Switch. This allows you to plan and use within the power budget of the Switch.
Remote
Port This show the number of the neighbor device's port which is connected to the Switch.
Desc. This shows the description of the neighbor device's port which is connected to the
Switch.
Model This shows the model name of the neighbor device. This field will show "-" for non-Zyxel
devices.
System Name This shows the system name of the neighbor device.
Location This shows the geographic location of the neighbor device.
Firmware This shows the firmware version of the neighbor device. This field will show "-" for non-Zyxel
devices.
IP This shows the IP address of the neighbor device. The IP address is a hyper link that you
can click to log into and manage the neighbor device through its web configurator. This
field will show "-" for non-Zyxel devices.
MAC This shows the MAC address of the neighbor device. This field will show "-" for non-Zyxel
devices.
PWR Cycle Click the Cycle button to turn OFF the power of the neighbor device and turn it back ON
again. A count down button (from 5 to 0) starts.
Note:
•
•
Reset to Default Click the Reset button to reset the neighbor device to its factory default settings. A
warning message "Are you sure you want to load factory default?" appears prompting
you to confirm the action. After confirming the action a count down button (from 5 to 0)
starts.
Note:
•
•
•
Chapter 7 Status and ZON
The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
If multiple neighbor devices use the same port, the Cycle button is displayed only on
the first device, others will show "-" instead.
The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
If multiple neighbor devices use the same port, the Reset button is not available and
will show "-" instead.
You can only reset Zyxel products.
XGS2210 Series User's Guide
62