13.2 Spanning Tree Protocol Status Screen
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Advanced Application > Spanning Tree Protocol to see the screen as
shown.
Figure 111 Advanced Application > Spanning Tree Protocol (Standalone mode)
Figure 112 Advanced Application > Spanning Tree Protocol (Stacking mode)
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the Switch. This
screen is described in detail in the section that follows the configuration section for each STP mode.
Click Configuration to activate one of the STP standards on the Switch.
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch. Click
Configuration in the Advanced Application > Spanning Tree Protocol.
Chapter 13 Spanning Tree Protocol
XGS2210 Series User's Guide
143