Technical Reference; Create An Ip-Based Vlan Example - ZyXEL Communications XGS2210-28 User Manual

Table 52 Advanced Application > VLAN: Port Based VLAN Setup (continued)
label
Outgoing
Apply
Cancel

9.12 Technical Reference

This section provides technical background information on the topics discussed in this chapter.

9.12.1 Create an IP-based VLAN Example

This example shows you how to create an IP VLAN which includes ports 1, 4 and 8. Follow these steps:
Activate this protocol based VLAN.
1
Type the port number you want to include in this protocol based VLAN. Type 1.
2
Give this protocol-based VLAN a descriptive name. Type IP-VLAN.
3
Select the protocol. Leave the default value IP.
4
Type the VLAN ID of an existing VLAN. In our example we already created a static VLAN with an ID of 5.
5
Type 5.
Leave the priority set to 0 and click Add.
6
Chapter 9 VLAN
Description
These are the egress ports; an egress port is an outgoing port, that is, a port through which a data
packet leaves. If you wish to allow two subscriber ports to talk to each other, you must define the
egress port for both ports. CPU refers to the Switch management port. By default it forms a VLAN
with all Ethernet ports. If it does not form a VLAN with a particular port then the Switch cannot be
managed from that port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2210 Series User's Guide
129