Navigating The Contivity 221 Webgui; Figure 2-2 Example Xmodem Upload - Nortel Contivity 221 User Manual

Step 4.
Continue to hold the RESET button for about 10 or 15 seconds. The Contivity 221 restarts.
Step 5. Release the RESET button and wait for the Contivity 221 to finish restarting.
2.3.2 Uploading a Configuration File Via Console Port
Step 1. Download the default configuration file from the Nortel Networks FTP site, unzip it and save it in
a folder.
Step 2. Turn off the Contivity 221, begin a terminal emulation software session and turn on the Contivity
221 again. When you see the message "Press Any key to enter Debug Mode within 3 seconds",
press any key to enter debug mode.
Step 3.
Enter "y" at the prompt below to go into debug mode.
Step 4. Enter "atlc" after "Enter Debug Mode" message.
Step 5.
Wait for "Starting XMODEM upload" message before activating Xmodem upload on your
terminal. This is an example Xmodem configuration upload using HyperTerminal.
Step 6.
Click Transfer, then Send File to display the following screen.

Figure 2-2 Example Xmodem Upload

Step 7. After successful firmware upload, enter "atgo" to restart the router.

Navigating the Contivity 221 WebGUI

2.4
The following summarizes how to navigate the WebGUI from the MAIN MENU screen.
Introducing the WebGUI 2-3
Type the configuration file's
location, or click Browse to
search for it.
Choose the Xmodem
protocol.
Then click Send.
Contivity 221 VPN Switch User's Guide