Table of Contents
Advertisement
32-2 Remote Management
Figure 32-1 Menu 24.11 – Remote Management Control
Menu 24.11 - Remote Management Control
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this screen.
Table 32-1 Menu 24.11 – Remote Management Control
FIELD
Telnet Server
Each of these read-only labels denotes a service or protocol.
FTP Server
Web Server
SNMP Service
DNS Service
Server Port
This field shows the port number for the service or protocol. You may
change the port number if needed, but you must use the same port
number to access the Contivity 221.
Server Access
Select the access interface (if any) by pressing [SPACE BAR], then
[ENTER] to choose from: LAN only, WAN only, ALL or Disable.
Secured Client
The default 0.0.0.0 allows any client to use this service or protocol to
IP
remotely access the Contivity 221. Enter an IP address to restrict
access to a client with a matching IP address.
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
317517-A Rev 00
Port = 23
Access = LAN only
Secured Client IP = 0.0.0.0
Port = 21
Access = LAN only
Secured Client IP = 0.0.0.0
Port = 80
Access = LAN only
Secured Client IP = 0.0.0.0
Port = 161
Access = LAN only
Secured Client IP = 0.0.0.0
Port = 53
Access = LAN only
Secured Client IP = 0.0.0.0
DESCRIPTION
EXAMPLE
23
LAN Only
(default)
0.0.0.0
Advertisement
Table of Contents
