Table of Contents
Advertisement
Sys Firewall Commands
The following chart lists and describes the sys firewall commands. Each of
these commands must be preceded by sys firewall when you use them. For
example, type sys firewall active yes to turn on the firewall.
Chart I-6 Sys Firewall
Commands
COMMAND
acl
disp
active
<yes|no>
cnt
disp
clear
dynamicrule
tcprst
rst
rst113
display
dos
smtp
display
ignore
ignore
dos
triangle
Command Interpreter I-19
DESCRIPTION
Displays ACLs or a specific ACL set # and rule #.
Active firewall or deactivate firewall
Enables/disables the firewall.
Displays the firewall log type and count.
Clears the firewall log count.
Displays the temporary firewall rules that the
device dynamically created.
Turns TCP reset sending on/off.
Turns TCP reset sending for port 113 on/off.
Displays the TCP reset sending settings.
Enables/disables the SMTP DoS defender.
Displays the SMTP DoS defender setting.
Sets if the firewall will ignore DoS attacks on the
lan/wan/dmz/wlan.
Sets if the firewall will ignore DoS attacks on the
lan/wan/dmz/wlan.
Sets if the firewall will ignore triangle route packets
on the lan/wan/dmz/wlan.
Contivity 221 VPN Switch User's Guide
Advertisement
Table of Contents
