Table of Contents
Advertisement
6-2 WAN Screens
Figure 6-1 WAN Setup: Route
The following table describes the fields in this screen.
Table 6-1 WAN Setup: Route
LABEL
WAN
The default WAN connection is "1' as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN. The default priority of
Traffic
the routes is WAN, Traffic Redirect and then Dial Backup (dial backup does not apply
Redirect
to all Contivity 221 models):
You have two choices for an auxiliary connection in the event that your regular WAN
Dial Backup
connection goes down. If Dial Backup is preferred to Traffic Redirect, then type "14" in
the Dial Backup Priority (metric) field (and leave the Traffic Redirect Priority (metric)
at the default of "15").
Apply
Click Apply to save your changes back to the Contivity 221.
Reset
Click Reset to begin configuring this screen afresh.
Configuring WAN ISP
6.4
To change your Contivity 221's WAN ISP settings, click WAN, then the WAN ISP tab.
differs by the encapsulation.
6.4.1
Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.
317517-A Rev 00
DESCRIPTION
The screen
Advertisement
Table of Contents
