Table of Contents
Advertisement
24-2 IP Static Route Setup
Figure 24-2 Menu 12. 1: Edit IP Static Route
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL:
`The following table describes the IP Static Route Menu fields.
Table 24-1 IP Static Route Menu Fields
FIELD
Route #
This is the index number of the static route that you chose in menu 12.
Route Name
Enter a descriptive name for this route. This is for identification purposes only.
Active
This field allows you to activate/deactivate this static route.
Destination IP
This parameter specifies the IP network address of the final destination. Routing is
Address
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet
Enter the IP subnet mask for this destination.
Mask
Gateway IP
Enter the IP address of the gateway. The gateway is an immediate neighbor of your
Address
Contivity 221 that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as your Contivity 221; over the WAN, the
gateway must be the IP address of one of the remote nodes.
Metric
Enter a number from 1 to 15 to set this route's priority among the Contivity 221's
routes (see the Metric section in the WAN and Dial Backup Setup chapter). The
smaller the number, the higher priority the route has.
317517-A Rev 00
DESCRIPTION
Advertisement
Table of Contents
