Chapter 23 Remote Node Setup; Introduction To Remote Node Setup; Remote Node Setup - Nortel Contivity 221 User Manual

Hide thumbs Also See for Contivity 221:

Table of Contents

A remote node is required for placing calls to a remote gateway. A remote node represents both

the remote gateway and the network behind it across a WAN connection. Note that when you use

menu 4 to set up Internet access, you are actually configuring a remote node. The following

describes how to configure Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node

Network Layer Options and Menu 11.5 - Remote Node Filter.

Remote Node Setup

From the main menu, select menu option 11 to open Menu 11 Remote Node Setup (shown

Then enter 1 to open Menu 11.1 Remote Node Profile and configure the setup for your regular

ISP. Enter 2 to open Menu 11.1 Remote Node Profile (Backup ISP) and configure the setup for

your Dial Backup port connection (see the chapter on WAN).

This chapter shows you how to configure a remote node.

Contivity 221 VPN Switch User's Guide