Table of Contents
Advertisement
35-2 Remote Management
If you enable remote management of a service, but have applied a filter
to block the service, then you will not be able to remotely manage the
service.
Enter 11, from menu 24, to display Menu 24.11 — Remote Management
Control (shown next).
Figure 35-1 Menu 24.11 Remote Management Control
Menu 24.11 - Remote Management Control
TELNET Server:
Port = 23
Secured Client IP = 0.0.0.0
FTP Server:
Port = 21
Secured Client IP = 0.0.0.0
Web Server:
Port = 80
Secured Client IP = 0.0.0.0
SNMP Service:
Port = 161
Secured Client IP = 0.0.0.0
DNS Service:
Port = 53
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 35-1 Menu 24.11 Remote Management Control
FIELD
Telnet Server
Each of these read-only labels denotes a service that you may use
FTP Server
to remotely manage the Contivity 251.
Web Server
SNMP Service
DNS Service
Port
This field shows the port number for the remote management
service. You may change the port number for a service if needed,
but you must use the same port number to use that service for
remote management.
Access
Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WAN only, All or Disable. The default is
LAN only.
317516-A Rev 00
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Access = ALL
DESCRIPTION
EXAMPLE
23
LAN only
Advertisement
Table of Contents
