Example Of Assigning A Static Route To The Management Interface; Enabling Remote Access Services - Nortel COMMISSIONING 8600 Commissioning

108 Remote connection configuration using the CLI

Example of assigning a static route to the management interface

Procedure steps
ATTENTION
The config bootconfig net mgmt route add command uses the natural
mask of the target subnet. Therefore, in the preceding example, what you
implement is the command:config bootconfig net mgmt route add
13.0.0.0 10.125.2.1. Additionally, this route does not appear in the routing
table of the Nortel Ethernet Routing Switch 8600. If you configure a 13.x.x.x
network for output using the I/O modules, the switch can experience connectivity
issues.

Enabling remote access services

Enable the remote access service to provide multiple methods of remote
access.
Prerequisites
•
Procedure steps
Step
1
2
3
Copyright © 2008 Nortel Networks
.
Action
If you locate a management station on the network of
11.0.0.0/255.0.0.0, and the next hop to that network from the
management interface is 10.127.231.1, enter the following
command to configure the management port:
config bootconfig net mgmt route add 11.0.0.0/255.0.0.0
10.127.231.1
The value 11.0.0.0/255.0.0.0 represents the target subnet; the
value 10.127.231.1 represents the gateway you use to point to
the target subnet.
When you enable an rlogin flag, you must configure an access policy
and specify the user name of who can access the switch. For more
information about the access policy commands, see Nortel Ethernet
Routing Switch 8600 Security, NN46205-601.
Action
Enable or disable the access service, in the run-time CLI, by
using the following command:
config bootconfig flags <access-service> <true|false>
Save the configuration.
From the boot-monitor CLI, while the switch is booting, press any
key to interrupt the autoboot process.
Nortel Ethernet Routing Switch 8600
Commissioning
NN46205-319 01.01 Standard
30 May 2008