Quantum Data 801GC, 801GF, 801GX Owner's And Programmer's Manual page 302

*WAI
Classification:
Command Syntax:
Limits:
Query Syntax:
Description:
Other Required Cmds:
Example:
XVSG
Classification:
Command Syntax:
Limits:
Description:
Other Required Cmds:
Example:
6-176
Chapter 6: Programming
WAIt for completion suffix
Direct processor control
<command>; *WAI
<command>
FMTU, IMGU, ALLU, BOOT, INIT, or SCAL
None
Normally, the generator returns a prompt immediately after either
an FMTU, IMGU, ALLU, BOOT, INIT, or SCAL command is
received - even before these commands have finished executing.
If the system controlling the generator must know when a
command has finished executing, use a semicolon to append
the suffix ... ; * W A I. This causes the generator to wait until all
processes have been completed before sending the > prompt.
The *WAI command is used as a suffix with the FMTU, IMGU,
ALLU, BOOT, INIT and SCAL commands.
F M T L v g a _ m 3 / / L o a d
/ / t o b u f f e r
I M G L S M P T E 1 3 3 / /
/ / i m a g e t o
A L L U ; * W A I / / U p d a t e
/ / b u f f e r c o n t e n t s
/ / p r o m p t u n t i l
Video Signal Gating
Format parameter setting
XVSG <red mode>, <green mode>, <blue mode>
< mode>
0 = OFF
1 = ON
The XVSG command determines which video outputs are active
when the format is selected. The same command controls both
the analog and digital video outputs.
The FMTU command instructs the generator to use the new
setting. The ALLU command updates hardware to the new setting
and redraws the test image.
X V S G 1 1 1 / / E n a b l e
F M T U / / U p d a t e h a r d w a r e
/ / b u f f e r c o n t e n t s
Model 801GC, 801GF & 801GX¥Rev. A
a f o r m a t f r o m
L o a d t h e S M P T E R P - 1 3 3
b u f f e r
h a r d w a r e t o c u r r e n t
a n d d e l a y
a l l d o n e
a l l c o l o r c h a n n e l s
t o c u r r e n t
m e m o r y