Quantum Data 801GC, 801GF, 801GX Owner's And Programmer's Manual page 290

SIZE
Classification:
Command Syntax:
Limits:
Query Syntax:
Query Response:
Description:
Other Required Cmds:
Example:
SMOD
Classification:
Command Syntax:
Limits:
Query Syntax:
Query Response:
Description:
Other Required Cmds:
Example:
6-164
Chapter 6: Programming
SIZE of bit field
Direct processor control
SIZE <size>
<size>
-32 to -1 or 1 to 32 bits
SIZE?
<size>
The SIZE command sets the field size (in base 10) used in
connection with the GETA, GETR, PUTA, and PUTR commands.
If a negative size is specified, then values given (or returned)
are sign extended to 32 bits. For example, if SIZE = -16 and a
16 bit field containing FFFF hex is fetched, then the value
FFFFFFFF hex is returned. The SIZE? query returns the current
setting of SIZE in base 10. SIZE is preset to 16 each time the
generator is powered on.
Note – This command will normally be used only with custom
applications and command files created by Quantum Data.
None
U s e o n l y w i t h c o d e
D a t a !
Sequence operating MODe
Sequence parameter setting
SMOD
<mode>
0 = Disable
1 = Enable manual step mode that stops at last step
2 = Enable manual step mode that wraps to first step
after last step
3 = Enable continuous auto stepping
SMOD?
<mode>
The SMOD command sets the sequence mode. The SMOD? query
returns the current setting of SMOD.
The SEQL command loads the sequence and SEQU starts to run
it.
S E Q L M Y _ S E Q / / L o a d
/ / e d i t b u f f e r
S E Q U / / S t a r t r u n n i n g
/ / t h e b u f f e r
S M O D 3 / / S e t t h e
Model 801GC, 801GF & 801GX¥Rev. A
s u p p l i e d b y Q u a n t u m
" M Y _ S E Q " d i r i n
t h e s e q u e n c e
s e q u e n c e m o d e
i n