Miscellaneous System Parameters; Direct Processor Control (Reserved) - Quantum Data 801GC, 801GF, 801GX Owner's And Programmer's Manual

Miscellaneous System Parameters

Direct Processor Control (Reserved)

The queries in this category are used to help iden-
tify the exact configuration of the generator.
*IDN IDeNtification (listed under "I")
VERF VERsion of Firmware
VERH VERsion of Hardware
These commands and queries are used to communi-
cate directly with the generator's microprocessor and
its internal functions. They are reserved for system
debugging and diagnostics by Quantum Data per-
sonnel as well as for special software applications
developed by Quantum Data.
Note – Indiscriminate use of these commands can cause the
g e n e r a t o r t o m a l f u n c t i o n . A n i r r e v e r s i b l e l o s s o f u s e r -
programmed data may also occur.
ADDR ADDRess
BASE BASE (radix)
BOOT warm BOOT
CALL CALL internal function
DCRD Display Code ReaD
GETA GET data from Absolute memory location
GETR GET data from Relative memory location
INIT INITialize to factory-default settings
PUTA PUT Absolute
PUTR PUT Relative
SCAL Self CALibrate
SIZE SIZE of bit field
*WAI WAIt for completion suffix
6-85