Chapter 2 DVOM Testing
Measuring the distance to a short
Measuring the distance to a short
16
2 Press the Display soft key and then select Resistance
Continuous.
3 Press the Actions soft key, and if not already selected,
select Insulation Resistance.
The test restarts and displays results.
The following procedure describes how to measure the
distance to a short.
NOTE:
Use this feature only when the resistance is 4 kΩ or less
(4 kΩ or less is almost always a hard short). If there is no
hard short on Tip and Ring (A and B), the measurement will
be inaccurate.
To measure distance
1
Connect the Tip (A), Ring (B), and Ground (Earth) leads
to the line under test.
2
Press the Display soft key and then select Distance to
Short.
HST-3000 Copper Testing User's Guide