Quick Tour; Status Leds - JDS Uniphase HST-3000 User Manual

Quick tour

Status LEDs

The following section describes the status indicators and
connections applicable to copper testing.
These six indicators report the status of the application. The
function of each LED is descried in
Table 7 Status LEDs
LED Function
Sync A two-color LED that reports the status of
modem synchronization.
– Flashing green indicates that the modems
– Solid green indicates that the modems have
– Solid red indicates a synchronization error
Data A two-color LED that reports the status of the
data connection.
– Flashing green indicates that the data con-
– Solid green indicates that a data connection
– Solid red indicates that a data connection
Error A two-color LED that reports error conditions.
Solid red indicates an error condition.
Alarm A two-color LED that indicates alarm conditions.
Solid red indicates an alarm condition.
HST-3000 Copper Testing User's Guide
are training.
synchronized.
has occurred.
nection is not yet established.
has been established with the network (so
that the HST-3000 may send and receive
data on the network).
error.
Chapter 1 Getting Started
Table 7.

Quick tour

5