JDS Uniphase HST-3000 User Manual page 68

Chapter 5 Locating cable faults
Locating faults using RFL
46
The multi gauge configuration screen appears.
c Press the Add soft key.
d Select the gauge and then press OK.
e Enter the temperature and then press OK.
f Enter the distance and then press OK.
You can delete an entire line by pressing the Delete
soft key.
g Repeat steps
h Press the Home navigation key to return to the RFL
screen.
6 To change the Ground hookup, do the following:
a Press the Display soft key.
b Select Change Ground Hookup.
c Use the left or right arrow key to specify whether
Green or Black is the Ground lead.
d Press the OK key.
NOTE:
The Ground hookup function is available only if you have a
Copper Measurement board rev 510. To verify, go to the
System>Tools>Options>Revisions screen and look for
"Copper". The Change Ground Hookup selection is not
available in K-Test.
HST-3000 Copper Testing User's Guide
c through f for each gauge of cable.